Sonosax SX-R4 (Firmware v3.1) Manual de usuario descargar pdf (Pagina 42)

User manual SONOSAX SX-R4 Page 42 of 53

6.1.4 Alarms

Certain situations require that the user has to be warned on a particular point. When this occurs, the SX-R4

intermittently flashes a warning concerning the detected problem and a beep tone is heard in the headphone.

The beep tone will disappear as son as any key is depressed. However the warning keeps flashing in the

display

One distinguishes 5 kinds of alarms, whose causes are explained below:

The Alarm AES occurs when one of the following conditions is checked:

• One or more Tracks is assigned from an AES input, but no valid AES signal is present.

• Input channels 7 & 8 are not assigned

• The incoming sampling frequency on the AES signal is out of tolerance ( +/- 0,2% )

The Alarm SYNC occurs when one of the following conditions is checked:

• the SX-R4 is set to WCK IN but no valid WordClock signal is present

• the SX-R4 is set to VIDEO IN but no valid Video signal is present

The Alarm TC occurs when one of the following conditions is checked:

• The Timecode is set to Internal Output but the format is set to Autodetect

• The Timecode is set on External No Jam, but no TC signal is present

• The Timecode is set on External No Jam, a TC signal is present but the format selected in the SX-R4

does not match with the detected format.

The Alarm HD or CF occurs when one of the following conditions is checked:

• The remaining Free space on a disk is less than 100Mb.

• The disk is too fragmented

• The CompactFlash Card bitrate is too low, recording on this media has been suspended

• The FAT32 partition cannot be initialized

The Alarm POWER occurs when t he power voltage is soon too low to maintain the SX-R4 running.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 52 53

Sin comentarios

Sonosax SX-R4 (Firmware v3.1) Manual de usuario Pagina 42